Commands In The Mstp Configuration Mode; Instance - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
6.3.5
Commands in the MSTP configuration mode
This section describes commands that you can call up in the MSTP configuration mode.
In the Global configuration mode, enter the
change to this mode.
● If you exit the MSTP configuration mode with the
configuration mode.
● If you exit the MSTP configuration mode with the
Privileged EXEC mode.
Requirements for changing to this mode:
● MSTP is enabled
● Base bridge mode: 802.1Q VLAN Bridge
● Compatibility mode: MSTP
6.3.5.1
instance
Description
With this command, you assign a range of VLANs to an MST instance.
Requirement
You are in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
Syntax
Call up the command with the following parameters:
instance <instance-id(1-64)> vlan <vlan-range>
The parameters have the following meaning:
Parameter
instance-id
vlan
vlan-range
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
spanning-tree mst configuration
Description
Number of the instance
Keyword for a VLAN connection
Range of VLANs assigned to an in-
stance
Network structures
6.3 Spanning Tree
command, you return to the Global
exit
command, you return to the
end
Range of values / note
1 ... 64
You can define up to 2 MSTP
instances.
Default:
The VLANs 1 – 4094 are as-
signed to instance "0"
-
enter the range limts with a hy-
phen or blank
command to
253
Advertisement
Table of Contents
