Switchport Access Vlan - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.2 VLAN
Syntax
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
Parameters
all
tagged
At system start or when using the
following defaults apply:
● The function is configured for
Result
The setting is enabled.
Further notes
You can display the status of this function and other information with the
config
6.2.3.2
switchport access vlan
Description
With this command, you assign an VLAN to an interface and configure the port VLAN
identifier (PVID) for it.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport access vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
vlan-id
208
Description
All frames (with and without VLAN variables) are accepted
Only frames with VLAN variables are accepted
command.
Description
Number of the addressed VLAN
command with the option
restart
.
all
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
or
memory
factory
show vlan port
Range of values / note
1 ... 4094
, the
Advertisement
Table of Contents
