Commands In The Interface Configuration Mode; Switchport Acceptable-Frame-Type - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
mgmt vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameters
vlan-id
Result
The Agent VLAN ID has been changed.
Further notes
You reset the
6.2.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
6.2.3.1
switchport acceptable-frame-type
Description
With this command, you configure which types of frames the interface accepts.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Number of the addressed VLAN
setting with the
dot1q-vlan
command.
base bridge-mode
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
Network structures
6.2 VLAN
Range of values
1 ... 4094
207
Advertisement
Table of Contents
