No Option - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Further notes
You display the setting with the
You delete the DHCP option with the
You configure the DHCP options 3, 6 and 66 with the
You disable the IPv4 address band with the
You configure all other DHCP options with the
7.3.4.6
no option
Note
The command is only available when the following requirements are met:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• The IPv4 address band is not enabled.
Description
With this command, you delete the DHCP option with the specified number.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no option <option-code>
The parameter has the following meaning:
Parameter
option-code
Result
The specified DHCP option is deleted.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show ip dhcp-server pools
no option
no pool-enable
option value-hex
Description
Code of the DHCP option
command.
command.
command.
option
command.
command.
Range of values / note
Enter a valid number.
Network protocols
7.3 DHCP server
295
Advertisement
Table of Contents
