Description; Working With The Command Line Interface (Cli) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Description
2.1
Working with the Command Line Interface (CLI)
Introduction
All the configuration settings for the device can be made using the Command Line Interface
(CLI). The CLI therefore provides the same options as Web Based Management (WBM).
You should read the detailed explanations of the parameters in the configuration manual
"SCALANCE W700 Web Based Management". The CLI allows remote configuration over
Telnet.
Note
Use with Windows 7
If you want to access the Command Line Interface in Windows 7, make sure that the
functions required for this are enabled in Windows 7.
Starting the CLI in a Windows console
Follow the steps outlined below to start the Command Line Interface in a Windows console:
1. Open a Windows console and type in the command "telnet" followed by the IP address of
the device you are configuring:
C:\>telnet <IP address>
2. Enter your login and password.
As an alternative, you can also enter the command "telnet" followed by the IP address of the
device you are configuring in the Start > Run menu.
Note
Requirement for use of the CLI
You should only use the command line interface if you are an experienced user.
Even commands that bring about fundamental changes to the configuration are executed
without a prompt for confirmation.
Errors in the configuration can mean that no further operation is possible in the entire
network.
Note
Command sets depend on the logged-on user. Changing configuration data is possible only
with the "admin" login.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
2
19
Advertisement
Table of Contents
