Wlan Data Rates-11Abg Selected Only (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
6.1.5.22
wlan data rates-11abg selected only (access point)
Description
With this command, you enable the "Use selected data rates only" function. Only the data
transmission speeds you specified with the
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
Syntax
Call the command without parameter assignment:
wlan data rates-11abg selected only
Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
You configure the data transmission speeds with the
You configure the transmission standard with the
160
wlan data rate-11abg
command.
show wlan data rates
no wlan data rates-11abg selected only
wlan data rate-11abg
wlan mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command are used.
command.
command.
command.
Advertisement
Table of Contents
