No Wlan Outdoor; Wlan Overlap-Ap Aging (Access Point) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
6.1.5.46
no wlan outdoor
Description
With this command, you disable the outdoor mode or enable the indoor mode. This setting is
activated as default.
In indoor mode, all the country-dependent permitted channels and transmit power settings
are available for operation in a building.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan outdoor
Result
The indoor mode is enabled or the outdoor mode is disabled.
Further notes
You display the setting with the
You enable the outdoor mode with the
See also
wlan outdoor (Page 182)
6.1.5.47
wlan overlap-ap aging (access point)
Description
With this command, you configure the aging time for the list of overlapping access points. If
an access point is inactive for longer than the set time, it is removed from the list.
Note
This command is available only in access point mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show wlan basic <wlan 0/X>
command.
wlan outdoor
Network structures
6.1 WLAN
command.
183
Advertisement
Table of Contents
