Show Ip Ssh; Commands In The Global Configuration Mode; Ssh-Server - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network protocols
7.9 SSH server
7.9.1
show ip ssh
Description
This command shows the settings of the SSH server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip ssh
Result
The settings for the SSH server are displayed.
7.9.2
Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.9.2.1
ssh-server
Description
With this command, you enable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
342
or
cli#
command to change to this mode.
configure terminal
or
end
exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command and are then in the
Advertisement
Table of Contents
