Show Spanning-Tree L2T-Edge - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
The parameters have the following meaning:
Parameter
interface-type
interface-id
cost
priority
portfast
rootcost
restricted-role
restricted-tcn
state
stats
detail
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The settings of the ports for the spanning tree function are displayed.
6.3.1.6
show spanning-tree l2t-edge
Description
This command displays the status of the layer 2 tunnel ports.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Type or speed of the interface
Module no. and port no. of the interface
Shows the port costs used to calculate
the lowest-cost path.
Shows the priority of the port.
Shows whether
fast
Shows the costs of the path to the root
bridge.
Shows whether
stricted-role
Shows whether
stricted-tcn
Shows the status of the interface.
Shows the counters of the various
BPDU transmissions.
Shows detailed information about the
spanning tree settings of the interface.
or
cli#
spanning-tree port-
is enabled.
spanning-tree re-
is enabled.
spanning-tree re-
is enabled.
Network structures
6.3 Spanning Tree
Range of values / note
Enter a valid interface.
-
-
-
-
-
-
-
-
-
223
Advertisement
Table of Contents
