Commands In The Interface Configuration Mode; Alias - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
3.1.10
Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
3.1.10.1
alias
Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <port-name>
The parameter has the following meaning:
Parameter
port-name
Result
The interface was assigned a name.
Further notes
You delete the name of the interface with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
interface
Description
Name of the interface
no alias
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
max. 63 characters
command.
Configuration
3.1 System
57
Advertisement
Table of Contents
