Renew Dhcp - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network protocols
7.2 DHCP client
Result
The configuration settings of the DHCP client are displayed.
7.2.3
renew dhcp
Description
This command reassigns an IP address to the selected interface via DHCP.
Requirement
● The IP address of the selected interface was assigned via DHCP.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
renew dhcp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-
type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The IP address is assigned again.
This address can be a different address from the previously assigned address.
Further notes
You can display the statistical information of the DHCP client with the
stats
You show the statistical information and the configuration of the IP interface with the
interface
278
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
command.
command.
Range of values
-
1 ... 4094
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
show ip dhcp client
show ip
Advertisement
Table of Contents
