Write Startup-Config - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Parameter
auto-logout
time
ntp
auto-save
wlan
all
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 23)".
If you call up the command without parameters, only the active operational settings of all
modules and all interfaces that do not match the preset values are displayed.
Result
The selected configuration settings of the device are displayed.
3.4.2
write startup-config
Description
With this command, you save the changes to the configuration in the configuration file.
The use of this command is required in the Trial mode. It can also be used in "auto save
mode".
Requirement
● The Trial mode is activated.
● You are in the Privileged EXEC mode.
The command prompt is:
*cli(...)#
Syntax
Call the command without parameter assignment:
write startup-config
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
Shows the configuration settings of the auto
logout function
Shows the configuration settings of the system
time
Shows the configuration settings of the Network
Time Protocol
Shows the configuration settings of the auto
save function
Shows the configuration settings of the WLAN
Shows all configuration settings
Configuration
3.4 Configuration Save & Restore
Range of values
-
-
-
-
-
-
77
Advertisement
Table of Contents
