Vlan; The "Show" Commands; Show Dot1D Mac-Address-Table - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Network structures
6.2 VLAN
6.2
VLAN
This section describes commands for configuring and managing virtual networks (VLANs).
6.2.1
The "show" commands
This section describes commands with which you display various settings.
6.2.1.1
show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
● In "base bridge-mode", the mode for the device is set to "transparent".
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address<aa:bb:cc:dd:ee:ff>]
The parameters have the following meaning:
Parameter
address
aa:bb:cc:dd:ee:ff
interface
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
196
[interface{<interface-type><interface-id>}]
Description
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Values
-
-
-
Enter a valid interface.
Advertisement
Table of Contents
