Wlan Signal-Recorder Stop (Client) - Siemens SCALANCE W760 Configuration Manual
Industrial wireless lan
Hide thumbs
Also See for SCALANCE W760:
- Configuration manual (464 pages) ,
- Operating instructions manual (50 pages) ,
- Operating instructions manual (51 pages)
Table of Contents
Advertisement
Functions specific to SCALANCE
4.2 Signal recorder
4.2.3
wlan signal-recorder stop (client)
Description
With this command, you stop the recording with the signal recorder.
Note
This command is only available in the client mode.
Requirement
● A recording was started.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
● The WLAN interface is enabled.
Call up the command with the following parameters:
wlan signal-recorder <wlan 0/X> stop
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The recording was stopped.
Further notes
You start the recording with the
88
or
cli#
Description
WLAN interface
wlan signal-recorder start
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Values or range of values
Enter a valid interface.
command.
Advertisement
Table of Contents
