No Ip Name Server - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Syntax
Call up the command with the following parameters:
ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
index
id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The IP address and, if specified, the index for a DNS server has been set.
7.1.2.12
no ip name server
Description
This command deletes the entry with the specified index for a DNS server. If you do not
specify an index, all entries are deleted.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
index
id
Result
The specified entries for the DNS servers were deleted.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Keyword for IPv4
IP address of the DNS server
Keyword for the index
Index of the DNS server
Description
Keyword for IPv4
IP address of the DNS server
Keyword for the index
Index of the DNS server
Network protocols
7.1 IPv4 protocol
Range of values / note
-
Enter a valid IP address
-
1 ... 3
Range of values / note
-
enter a valid IPv4 address
-
1 ... 3
293
Hide quick links:
Advertisement
Table of Contents
