Spanning-Tree Mst Hello-Time - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.3 Spanning Tree
Further notes
You configure the setting with the
You display these settings and other information with the commands that start with
spanning tree ...
6.3.4.10
spanning-tree mst hello-time
Description
With this command, you configure the Hello time after which the bridge sends its
configuration frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
The parameter has the following meaning:
Parameter
seconds
Result
The setting for the hello time is configured.
Further notes
You can reset the setting for the hello time to the default with the
hello-time
You display this setting and other information with the commands that start with
spanning tree ...
274
spanning-tree mst
.
Description
Time after which the bridge sends its
configuration frames (BPDUs)
command.
.
command (properties).
Range of values / note
1 ... 2
Default: 2
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show
no spanning-tree mst
show
Hide quick links:
Advertisement
Table of Contents
