hit counter script

Renew Dhcp - Siemens SIMATIC NET Configuration Manual

Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs Also See for SIMATIC NET:
Table of Contents

Advertisement

Network protocols
7.2 DHCP client
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip dhcp client
Result
The configuration settings of the DHCP client are displayed.
7.2.2

renew dhcp

Description
This command reassigns an IP address to the selected interface via DHCP.
Requirement
● The IP address of the selected interface was assigned via DHCP.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
renew dhcp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-
type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
300
or
cli#
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
1 ... 4094
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05

Advertisement

Table of Contents
loading

This manual is also suitable for:

Scalance w720Scalance w760

Table of Contents

Save PDF