Commands In The Global Configuration Mode; Snmpagent; No Snmpagent - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
7.4.2
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.4.2.1
snmpagent
Description
With this command, you enable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
snmpagent
Result
The SNMP agent function is enabled.
Further notes
You disable the SNMP agent function with the
7.4.2.2
no snmpagent
Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command to change to this mode.
configure terminal
or
end
exit
no snmpagent
Network protocols
command and are then in the
command.
7.4 SNMP
331
Hide quick links:
Advertisement
Table of Contents
