Ip Route; No Ip Route - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
7.1.2.5
ip route
Description
With this command, you configure a static entry in the IP routing table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip route <gateway>
The parameter has the following meaning:
Parameter
gateway
Result
The entry is configured.
Further notes
You delete an entry from the IP routing table with the
You display the IP routing table with the
7.1.2.6
no ip route
Description
With this command, you delete a static entry from the IP routing table.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Specifies the IP address of the gateway
Range of values / note
enter a valid IP address
no ip route
command.
show ip route
Network protocols
7.1 IPv4 protocol
command.
289
Hide quick links:
Advertisement
Table of Contents
