Show Vlan - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.2 VLAN
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
6.2.1.5
show vlan
Description
This command shows the specific information for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
220
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or VLAN range
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
-
1 ... 4094
-
-
-
Enter a valid interface.
Hide quick links:
Advertisement
Table of Contents
