Result
EtherNet/IP is enabled or disabled after the next restart.
Further notes
You can display the current EtherNet/IP configuration with the
3.1.9.5
interface
Description
With this command, you change to the Interface Configuration mode.
There you can edit the settings for one interface. You select the interface with the
parameters of this command. If you specify a logical interface that does not exist, it will be
created. The name of the selected interface is displayed in the command prompt.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
interface{vlan<vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
vlan
vlan-id
interface-type
interface-id
Result
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
<interface-type><interface-id>}
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Module no. and port no. of the interface
Configuration
3.1 System
command.
show ethernetip
Range of values / note
-
1 ... 4094
Enter a valid interface.
53