Spanning-Tree L2T-Auto-Edge; No Spanning-Tree L2T-Auto-Edge - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
6.3.3.5
spanning-tree l2t-auto-edge
Description
This command specifies that at all layer 2 tunnel ports it should be automatically detected
whether or not an end device is connected.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree l2t-auto-edge
Result
The automatic detection is enabled.
Further notes
You disable the automatic detection with the
You can display the status of this function with the
6.3.3.6
no spanning-tree l2t-auto-edge
Description
With this command, you disable automatic detection of an end device at layer 2 tunnel ports.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree l2t-auto-edge
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
no spanning-tree l2t-auto-edge
show spanning-tree l2t-edge
Network structures
6.3 Spanning Tree
command.
command.
253
Hide quick links:
Advertisement
Table of Contents
