Show Wlan Allowed Channels - Siemens SIMATIC NET Configuration Manual
Industrial wireless lan to ieee 802.11n command line interface
Hide thumbs
Also See for SIMATIC NET:
- System manual (372 pages) ,
- Manual (300 pages) ,
- Operating instructions manual (90 pages)
Table of Contents
Advertisement
Network structures
6.1 WLAN
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following settings are displayed:
● RTS/CTS threshold
● Fragmentation length threshold
● HW retries
In Access Point mode, the following additional settings are displayed:
● Beacon interval
● DTIM
● Force roaming on link down
● Overlap AP aging interval
6.1.1.2
show wlan allowed channels
Description
This command displays the available wireless channels. If you have selected channels
explicitly for wireless communication, this information is also displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan allowed channels <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
132
Description
WLAN interface
or
cli#
Description
WLAN interface
Range of values / note
Enter a valid interface.
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Hide quick links:
Advertisement
Table of Contents
