Table of Contents
Advertisement
IBM Infoprint 1130/1140
202 Paper Jam Open Rear Door Message displays and a sheet of
paper is jammed prior to the pass through sensor flag or 202
Paper Jam Open Rear Door Message displays, a sheet of paper
feeds out to the standard bin even though bin X is selected and
paper exits half way out of the redrive assembly.
Service Tip: For this type of problem check the
Error Codes" on page
202 paper jam message can also occur prior to the high-capacity
output stacker pass through sensors.
FRU
1
Lower Pass Thru Sensor/
Flag Assembly
2
High-Capacity Output
Stacker Drive belt(s), Drive
Pulleys, Belt Idlers, and Belt
Tension Springs
3
Mechanical Linkage/Motor
Assembly (Upper or Lower)
2-98
Service Manual
2-10. They can help isolate the problem. A
Action
Check the flag for correct operation,
binding, broken parts or interference
from the sensor cable. If incorrect,
repair as necessary. If correct, check
to make sure the lower pass thru
sensor is correctly connected to J3 on
the lower control board. Disconnect
the pass thru sensor cable and check
the voltage at J3-3. The voltage
measures approximately +5 V dc. If
incorrect, check the voltage at J3-2.
The voltage measures approximately
0 V dc. If incorrect, replace the sensor
assembly. If this does not fix the
problem, replace the lower control
board.
Check to ensure the output stacker
drive belt or the failing assembly is
correctly installed on the drive pulley
and belt idler pulley. Check the belt
tension spring to make sure it is not
loose or broken. Repair as necessary.
If the DC motor is functioning properly
check the gears, clutch and other
linkage parts for correct operation and
any signs of wear, broken gear teeth
or damaged parts. If incorrect, replace
the mechanical linkage assembly/DC
Motor Assembly.
"Base Printer Sub
Advertisement
Table of Contents
