Table of Contents
Advertisement
IBM Infoprint 1130/1140
Stacker Sub Error Codes
First 6
Bytes Sub
Error Code
Data - Note:
xx can be
any value
84 xx 14
84 xx 15
84 xx 16
95 xx 00 x1
x2
95 xx 01 x1
x2
98 xx 02 x1
x2 x3
Explanation
There is media in stacker 1 during POST. Usually associated
with a 271 Paper Jam Error message. May be displayed when
a finisher option is installed in lowest or first position above
the printer.
If present, remove the media from stacker 1. If the error
continues to be displayed or there is no media present in the
stacker, check the pass thru sensor and flag of stacker 1 or, if
installed, check the option below stacker 1.
There is media in stacker 2 during POST. If present, remove
the media from stacker 2. If the error continues to be
displayed, or there is no media present in the stacker, check
the pass thru sensor and flag of stacker 2, or check the option
below stacker 2.
There is media in stacker 3 during POST. If present, remove
the media from stacker 3. If the error continues to be
displayed, or there is no media present in the stacker, check
the pass thru sensor and flag of stacker 3, or check the option
below stacker 3.
Stacker sensor x never became uncovered.
(x1=sensor's stacker, x2=stacker destination)
Check stacker x to see if a piece of paper is over the sensor. If
not, check to see if the sensor and flag are working correctly.
Stacker sensor x never was covered or actuated.
(x1=sensor's stacker, x2=stacker destination)
Check stacker x to see if the sensor and flag are operating
correctly.
Stacker x did not indicate that a page had been received in
the output.
(x1=stacker destination)
Diagnostic Information
2-21
Advertisement
Table of Contents
