Table of Contents
Advertisement
P U
S H
5
Figure 51. Release the upper CMA assembly
2. Move the upper CMA to the left to swing it out of the way.
3. To release the lower CMA, push the latch on the support rail connector 11 to
12
11
P U
S H
Figure 52. Release the lower CMA assembly
4. Move the lower CMA to the right to swing it out of the way.
Installing or replacing the cable-management arm: 2076-92F
Use these procedures to install the cable-management arm (CMA) for the 2076-92F
expansion enclosure. You can also use these procedures to replace a faulty CMA
assembly.
About this task
As part of the initial installation of the 2076-92F expansion enclosure, you must
attach the CMA. You might also need to replace a faulty CMA with a new one
from FRU stock.
The cable management arm (CMA) consists of an upper arm and a lower arm
assembly, as Figure 53 on page 61 shows.
60
Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
6
a. To reattach the upper CMA to the rail, reverse the procedure.
release it from the connector base 12 on the left rail.
a. To reattach the lower CMA to the rail, reverse the procedure.
s i s
a s
C h
Advertisement
Table of Contents
