Installing A Management Module - IBM 8852 - BladeCenter H Rack-mountable Service Manual
Problem determination and service guide
Hide thumbs
Also See for 8852 - BladeCenter H Rack-mountable:
- Installation and user manual (82 pages)
Table of Contents
Advertisement
Installing a management module
To install a management module, complete the following steps.
Note: These instructions assume that the BladeCenter unit is connected to power.
1. Make sure that the release handle on the module is in the open position.
2. Slide the module into the module bay until it stops.
3. Push the release handle to the closed position.
4. Reconnect all cables to the module.
5. If this is the only management module in the BladeCenter unit, restore the
configuration from the configuration file that you saved when you removed the
old management module. See the BladeCenter Management Module User's Guide
and the BladeCenter Management Module Command-Line Interface Reference Guide
for detailed information about restoring a saved configuration file.
6. Make sure that the OK LED on the module is lit.
Module
filler
Release handle
Management
(open)
module
Chapter 4. Removing and replacing BladeCenter components
47
Hide quick links:
Advertisement
Table of Contents
