Table of Contents
Advertisement
Speaker
Description
Speaker with rubber rivets
The speaker is secured to the front of the chassis with three rubber rivets that are part of the speaker.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Lay the computer on its side so you can access both the inside and outside of the front of the
computer.
5.
Disconnect the cable from the white system board connector labeled INT_SPKR.
6.
From the front, squeeze the thicker part of the rubber rivets next to the chassis wall.
Figure 7-43
(Access Panel on page
(Front Bezel on page
Speaker rubber rivets
(Preparation for Disassembly on page
43).
45).
Spare part number
666885-001
42).
Speaker
83
Advertisement
Table of Contents
Troubleshooting
