Table of Contents
Advertisement
Speaker
The speaker is attached to the front of the rotating drive cage.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the drive cage
5.
From the outside, front of the chassis, remove the two Phillips screws that secure the speaker.
6.
From the inside of the chassis, disconnect the speaker cable from the white system board labeled SPKR (1),
remove the cable from the clips in the front I/O bracket (2), and then remove the speaker from the front of
the chassis (3).
To install the speaker, reverse the removal procedures.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
19).
(Drive cage on page
22).
18).
17).
Speaker
49
Advertisement
Table of Contents
