Table of Contents
Advertisement
NOTE:
The system will not operate properly if you install unsupported DIMMs.
Populating DIMM Sockets
Populate the DIMM sockets in the following order: XMM1, XMM3
The system will automatically operate in single channel mode, dual channel mode, or flex mode,
depending on how the DIMMs are installed.
●
The system will operate in single channel mode if the DIMM sockets are populated in one
channel only.
●
The system will operate in a higher-performing dual channel mode if the total memory capacity
of the DIMMs in Channel A is equal to the total memory capacity of the DIMMs in Channel B.
The technology and device width can vary between the channels. If Channel A is populated with
one 1-GB DIMM and Channel B is populated with one 2-GB DIMM, the system will operate in
dual channel mode.
●
The system will operate in flex mode if the total memory capacity of the DIMMs in Channel A is
not equal to the total memory capacity of the DIMMs in Channel B. In flex mode, the channel
populated with the least amount of memory describes the total amount of memory assigned to
dual channel and the remainder is assigned to single channel. For optimal speed, the channels
should be balanced so that the largest amount of memory is spread between the two channels.
If one channel will have more memory than the other, the larger amount should be assigned to
Channel A. If you are populating the sockets with one 2-GB DIMM, and one 1-GB DIMM,
Channel A should be populated with the 2-GB DIMM, and Channel B should be populated with
the 1-GB DIMM. With this configuration, 2 GB will run as dual channel and 1 GB will run as
single channel.
●
In any mode, the maximum operational speed is determined by the slowest DIMM in the system.
The system will automatically operate in single channel mode, dual channel mode, or flex mode,
depending on how the DIMMs are installed.
Removing Memory Modules
CAUTION:
to drain before adding or removing memory modules. Regardless of the power-on state, voltage is
always supplied to the memory modules as long as the computer is plugged into an active AC outlet.
Adding or removing memory modules while voltage is present may cause irreparable damage to the
memory modules or system board.
The memory module sockets have gold-plated metal contacts. When upgrading the memory, it is
important to use memory modules with gold-plated metal contacts to prevent corrosion and/or
oxidation resulting from having incompatible metals in contact with each other.
Static electricity can damage the electronic components of the computer or optional cards. Before
beginning these procedures, ensure that you are discharged of static electricity by briefly touching a
grounded metal object.
When handling a memory module, be careful not to touch any of the contacts. Doing so may damage
the module.
1.
Prepare the computer for disassembly
2.
Remove the access panel
50
Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis
You must disconnect the power cord and wait approximately 30 seconds for the power
(Access Panel on page
(Preparation for Disassembly on page
43).
42).
Advertisement
Table of Contents
Troubleshooting
