Table of Contents
Advertisement
Chapter 2. Installing and configuring the network
management card
This chapter describes how to install the network management card in an
uninterruptible power supply (UPS) and how to configure the card to use the web
interface.
Installation checklist
Before you install the network management card, make sure that you have the
following items:
v Network management card
v Serial communication cable for configuration (comes with the network
v Ethernet cable (purchased separately)
v Phillips screwdriver (purchased separately)
Handling static-sensitive devices
Attention:
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
© Copyright IBM Corp. 2010, 2012
management card)
Static electricity can damage the UPS and other electronic devices. To
you.
electrostatic-discharge wrist strap, if one is available.
metal surface on the outside of the UPS for at least 2 seconds. This drains static
electricity from the package and from your body.
5
Hide quick links:
Advertisement
Table of Contents
