Table of Contents
Advertisement
test specific string
Viewing the test log
When the tests have been completed, you can view the test log by selecting Utility
from the top of the screen and then selecting View Test Log.
Notes:
1. You can view the test log only while you are in the diagnostic programs. When
2. To save the test log to a diskette, you must use a diskette that you have
For information about the system error log, see "Error logs" on page 14 and
"Configuration/Setup Utility main menu" on page 28.
Viewing the System Event/Error log
You can also view the System Event/Error log from the diagnostic programs. See
the instructions at "Error logs" on page 14.
Diagnostic error messages
Error messages may appear when you run the diagnostic programs.
Notes:
1. Depending on the server configuration, some of these error messages might not
2. If diagnostic error messages appear that are not listed, make sure that the
For information about specific diagnostic error codes, see "Diagnostic error codes"
on page 120.
Failed This result occurs when the diagnostic test discovers an
error.
User Aborted
This result occurs when you stop the diagnostic test before
it is complete.
Not Applicable
This result occurs when you specify a diagnostic test for a
device that is not present.
Aborted
This result occurs when the test could not proceed, for
example, because of the system configuration.
Warning
This result occurs when a possible problem is reported
during the diagnostic test, such as when a device that is to
be tested is not installed.
Additional information that you can use to analyze the problem.
you exit the diagnostic programs, the test log is cleared (saved test logs are not
affected). To save the test log so that you can view it later, click Save Log on
the diagnostic programs screen and specify a location and name for the saved
log file.
formatted yourself; this function does not work with preformatted diskettes. If the
diskette has sufficient space for the test log, the diskette may contain other
data.
appear when you run the diagnostic programs.
server has the latest levels of BIOS, Remote Supervisor Adapter, ServeRAID,
and diagnostics microcode installed.
17
Diagnostics
Advertisement
Table of Contents
Troubleshooting
