Table of Contents
Advertisement
Procedure
10. Run the next recommended fix procedure in the management GUI to set the
Removing the display panel assembly: 2076-92F
You can remove the display panel assembly from a 2076-92F expansion enclosure.
Procedure
1. Slide the expansion enclosure out of the rack, as described in "Removing an
2. Remove the top cover, as described in "Removing the top cover: 2076-92F" on
3. Press the release tab at the top of the display panel assembly, as shown in
116
Storwize V7000 Gen2 and Gen2+: Quick Installation Guide
1. Remove the front display (4U) and PSU (1U) fascia from the old enclosure, as
described in "Removing the fascia: 2076-92F" on page 79.
a. Install the front display (4U) and PSU (1U) fascia on the new enclosure, as
described in "Installing or replacing the fascia: 2076-92F" on page 74.
2. Remove the display panel assembly from the old enclosure, as described in
"Removing the display panel assembly: 2076-92F."
a. Install the display panel assembly into on the new enclosure, as described
in "Installing or replacing the display panel assembly: 2076-92F" on page
118.
3. Remove the fan interface boards from the old enclosure, as described in
"Removing a fan interface board: 2076-92F" on page 110.
a. Install the fan interface boards into on the new enclosure, as described in
"Installing or replacing a fan interface board: 2076-92F" on page 86.
4. Remove the inner section of the slide rail from the old enclosure, as described
in "Removing the support rails: 2076-92F" on page 121.
5. Attach the inner rail section to the new enclosure, as described in "Installing
or replacing the support rails: 2076-92F" on page 48.
6. Replace the new enclosure in rack, as described in "Installing or replacing an
expansion enclosure in a rack: 2076-92F" on page 51.
7. Reinstall the remaining parts into the enclosure, as described in the following
topics. You can install the parts in any order.
Important: Ensure that a mechanical lift is available and in place to support
the additional weight as the FRUs are reinstalled in the enclosure.
v "Installing or replacing a power supply: 2076-92F" on page 76
v "Installing or replacing a drive: 2076-92F" on page 66
v "Installing or replacing a secondary expander module: 2076-92F" on page
71
v "Installing or replacing an expansion canister: 2076-92F" on page 54
v "Installing or replacing a fan module: 2076-92F" on page 85
v "Installing or replacing the top cover: 2076-92F" on page 65
8. Reconnect the SAS cables, as described in "Removing and installing a SAS
cable: 2076-92F" on page 82.
9. Reconnect the power cables, as described in "Powering on the optional
2076-92F expansion enclosures" on page 125.
serial number of the 2076-92F enclosure.
expansion enclosure from a rack: 2076-92F" on page 89.
page 47.
Figure 110 on page 117.
Advertisement
Table of Contents
