Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 77
Connectivity module
Hide thumbs
Also See for SIMOTICS CONNECT 400:
- Operating instructions manual (156 pages) ,
- Manual (101 pages) ,
- Operating instructions manual (120 pages)
Table of Contents
Advertisement
"Device overview" page
When the "SIDRIVE IQ Config" application starts, by default, you see a list of all of the currently
visible assets on the "Device overview" page. You can also display all of the assets visible in the
history. A list entry contains the information about an asset. The following diagram explains the
pictograms in a list entry.
①
②
③
④
⑤
⑥
⑦
⑧
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL
To identify an asset, press the motor icon (LED of the connectivity module flashes)
Note: Identification is not possible if firmware version < 0.6.0 is installed. A message to that
effect is displayed requesting you to update the firmware.
BLE name of the currently selected connectivity module
Bluetooth interface signal strength display
Wi-Fi configuration status of the connectivity module:
•
"Black" status: Wi-Fi configured and operating correctly
•
"Red" status: Wi-Fi not configured or has a fault
Connection status of the connectivity module to the MindSphere application "SIDRIVE IQ Fleet"
(onboarding status)
•
"Black" status: Connected
•
"Yellow" status: No Onboarding yet
•
"Red" status: Error during upload
Status of the connectivity module battery:
•
"Black" status: sufficient charge
•
"Orange" status: 40% or less
•
"Red" status: 20% or less
Note: Replace the battery in good time. If disturbances occur in data transmission, replace the
*)
batteries (Page 196).
Button for opening help
Button for establishing a connection to the connectivity module
If necessary, confirm a pairing request to establish the Bluetooth connection.
*)
Commissioning
6.3 Commissioning with iOS
75
Advertisement
Table of Contents
