Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 158
Connectivity module
Hide thumbs
Also See for SIMOTICS CONNECT 400:
- Operating instructions manual (156 pages) ,
- Manual (101 pages) ,
- Operating instructions manual (84 pages)
Table of Contents
Advertisement
Maintenance
8.5 Replacing the connectivity module
Result
The following message is displayed after the module has been successfully replaced.
After commissioning has been completed, you are automatically logged off from the device
and the Bluetooth connection is disconnected.
The connectivity module starts to record data and transfer data in the preselected intervals.
After the first measurements, a first connection is automatically established to SIDRIVE
IQ Fleet, which means that you can see the actual connection status shortly after
commissioning.
The connectivity module automatically starts the calibration procedure on the motor. It
requires 10 measuring cycles with the motor in the "ON" state and 10 measuring cycles
with the motor in the "OFF" state. Precise data is only displayed in SIDRIVE IQ Fleet as an
"operating state" signal after the calibration process:
Value "0": Motor off (OFF), sensor calibrated
Value "1": Motor status not defined, sensor not calibrated
Value "3": Motor on (ON), sensor calibrated
No additional measures are required to support calibration.
156
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL
Advertisement
Table of Contents
