Table of Contents
Advertisement
GE
Direction 5370626-100, Revision 18
3-5-2-2
Scanner Shutdown
Disconnect the Mains Power Cable if necessary. For example: Relocating the scanner.
3-5-3
Transducer Connection
1.) Carefully open the system LCD display, plug the probe connector into the probe port, then lock the
probe latch upward.
NOTE:
Please ensure that the probe latch is in an unlocked position before you connect the probe to the
system.
NOTE:
It is not necessary to turn OFF power to connect or disconnect a probe.
LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Figure 3-8 Connect the probe
Chapter 3 System Setup
Probe Latch
3-11
Advertisement
Table of Contents
