Flow Chart - General Settings; Flow Chart - Pulse Encoder - Siemens SINAMICS CU240S DP-F Operating Instructions Manual
Hide thumbs
Also See for SINAMICS CU240S DP-F:
- Operating instructions manual (232 pages) ,
- Parameter manual (418 pages) ,
- Operating instructions manual (410 pages)
Table of Contents
Advertisement
2.7.8.2
Flow chart - General settings
Commissioning the application - flow charts
The parameters designated with an "*" offer more setting possibilities than are listed here.
Refer to the parameter list for additional setting possibilities.
General settings
Parameter
Description (Factory setting: bold)
P0003 = 3
User access level*
1: Standard: Allows access into most frequently used parameters.
2: Extended: Allows extended access e.g. to inverter I/O functions
3: Expert: For expert use only
P0210 = ?
Supply voltage (enter the voltage in V)
This parameter enters the real line supply voltage to which the Inverter is connected. Only
necessary if P1254 = 0 (default: P1254 = 1).
P0290 = 2
Inverter overload reaction
This defines the response of the Inverter to an internal overtemperature.
0: Reduce output frequency
1: Trip (F0004)
2: Reduce pulse frequency and output frequency
3: Reduce pusle frequency then trip (F0004)
P0335 = 0
Motor cooling (enter the motor cooling system)
0: Self-cooled using the shaft mounted fan attached to the motor
1: Force-cooled using the separately powered cooling fan
2: Self-cooled and internal fan
3: Force-cooled and internal fan
2.7.8.3
Flow chart - Pulse encoder
Pulse Encoder
Parameter
Description (Factory setting: bold)
P0400 = 0
Select encoder type *
or
0: Disabled (no encoder fitted)
P0400 = ?
2 or 12: Two quadrature encoder (two channels)
P0408 = ?
Number of encoder pulses (Only if encoder is fitted)
Enter the number of encoder pulses per revolution. The number of encoder pulses per
revolution P0408 is limited by the maximum pulse frequency of the pulse encoder module
(f
= 300 kHz)
max
Control Units CU240S
Operating Instructions (Compact), 04/2006, A5E00766042B AA
Commissioning (software)
2.7 Commissioning modes
Setting
Setting
2-31
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
