Pci Riser Card; System Board - IBM xSeries 330 Hardware Maintenance Manual
Type 8675
Hide thumbs
Also See for xSeries 330:
- Hardware maintenance manual (158 pages) ,
- Hardware maintenance manual (194 pages)
Table of Contents
Advertisement
PCI riser card
To remove the PCI riser card:
Note: Read"Safety information" on page 135 and "Before you begin" on page 48.
1. Power off the server.
2. Remove the cover. See "Removing the cover" on page 51.
3. Remove any adapters and put them in a safe place.
4. Disconnect cables.
5. Gently lift up on the card to disconnect it from the system board port.
System board
To remove the system board:
Note: Read"Safety information" on page 135 and "Before you begin" on page 48.
1. Power off the server.
2. Remove the cover. See "Removing the cover" on page 51.
3. Disconnect all cables from the system board.
4. Remove the adapter retaining latch (see "Installing a microprocessor" on
5. Remove the microprocessors. See "Installing a microprocessor" on page 88.
6. Remove the memory modules. See "Installing memory" on page 86.
7. Remove screws from the system board.
8. Remove the four screws from the rear of the server.
9. Pull up on the system board to remove from the chassis.
112
Hardware Maintenance Manual: xSeries 330 Type 8675
page 88).
Advertisement
Table of Contents
