Hard Disk Drive Backplane; Power Supply - IBM xSeries 330 Hardware Maintenance Manual
Type 8675
Hide thumbs
Also See for xSeries 330:
- Hardware maintenance manual (158 pages) ,
- Hardware maintenance manual (194 pages)
Table of Contents
Advertisement
Hard disk drive backplane
To remove the hard disk drive backplane:
Notes:
1. Read"Safety information" on page 135 and "Before you begin" on page 48
1. Power off the server.
2. Remove the cover. See "Removing the cover" on page 51.
3. Disconnect the backplane cable from the system board.
4. Pull out the hard drives in order to disconnect them from the backplane.
5. Remove the screw from the top of the backplane bracket.
6. Gently but firmly lift the backplane bracket and board up from the chassis.
Power supply
To remove the power supply:
Note: Read"Safety information" on page 135 and "Before you begin" on page 48.
1. Power off the server.
2. Remove the cover. See "Removing the cover" on page 51.
3. Disconnect the cables that connect the power supply to the system board.
4. Remove the screws (2) from the side of the chassis.
5. Remove the screws (2) at the back of the chassis and power supply. (To gain
6. Slide the power supply away from the side of the chassis and lift up to remove.
access to these screws (2) you must pull out on the cover-release lever.)
FRU information (service only)
111
Advertisement
Table of Contents
