Installing An Adapter - IBM xSeries 330 Hardware Maintenance Manual
Type 8675
Hide thumbs
Also See for xSeries 330:
- Hardware maintenance manual (158 pages) ,
- Hardware maintenance manual (194 pages)
Table of Contents
Advertisement
v PCI slot 1 and the integrated SCSI controller are on PCI bus A; the system board
v The system scans PCI slots 1 and 2 to assign system resources. By default the
Installing an adapter
Complete the following steps to install an adapter:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, refer to
"Handling static-sensitive devices" on page 138.
54
Hardware Maintenance Manual: xSeries 330 Type 8675
and all other integrated devices are on PCI bus B.
system starts (boots) devices in the following order: System SCSI devices, then
PCI devices.
Note: To change the startup (boot) order, start the Configuration/Setup Utility
program, select Start Options from the main menu; then, select the PCI
SCSI adapter boot option.
1. Review the safety precautions that are listed in "Related service information"
on page 135.
2. Turn off the server and peripheral devices.
3. Remove all external cables and power cords from the server; then, remove the
server from the rack and remove the cover. For more information see
"Removing the cover" on page 51.
4. Remove the expansion slot clip that holds the expansion slot cover in place by
sliding it upward and off the frame of the server.
Cover release
Screws
lever
Advertisement
Table of Contents
