Cable Management - HP Pro 3330 Maintenance And Service Manual
Microtower small form factor
Hide thumbs
Also See for Pro 3330:
- Maintenance & service manual (226 pages) ,
- Illustrated parts & service map (3 pages) ,
- User manual (74 pages)
Table of Contents
Advertisement
10.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11.
Reconfigure the computer, if necessary.
Cable Management
Always follow good cable management practices when working inside the computer.
●
Keep cables away from major heat sources like the heat sink.
●
Do not jam cables on top of expansion cards or memory modules. Printed circuit cards like these
are not designed to take excessive pressure on them.
●
Some flat ribbon cables come prefolded. Never change the folds on these cables.
●
Never bend a SATA data cable tighter than a 30 mm (1.18 in) radius.
●
Never crease a SATA data cable.
●
Do not rely on components like the drive cage, power supply, or computer cover to push cables
down into the chassis. Always position the cables to lay properly by themselves.
When removing the power supply power cable from the P1 connector on the system board, always
follow these steps:
1.
Squeeze on the top of the retaining latch attached to the cable end of the connector (1).
2.
Grasp the cable end of the connector and pull it straight up (2).
CAUTION:
damage the cable and result in a failed power supply.
102 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
Always pull the connector - NEVER pull on the cable. Pulling on the cable could
Advertisement
Table of Contents
