Table of Contents
Advertisement
Major Topic Heading
E15h SPRAYER- Specifications
11. SPECIFICATIONS
11.1
CONSOLE
•
Supply Voltage
The Console's power leads must be connected directly to the tractors
battery terminals.
No attempt should be made to connect the system to positive earth vehicle.
Damage will result and Warranty will become void.
•
Supply Current Console
Maximum Solenoid supply current
Maximum Electric Regulator Valve Motor Current: approx. 250milli-amps
11.2 GROUND SPEED, FAN SPEED, AUXILIARY & PUMP SHAFT SENSORS
Ground Speed Sensor,:
Fan Speed Sensor and
Auxiliary Shaft Sensors:
Sensor to Magnet Distance
Supply Voltage
Signal Voltage:
11.3 FLOW SENSORS
11.3.1 Reed Switch Type
• With Switch OFF:
• Switch ON Resistance:
• 2 Wire Only
• Maximum contact Current:
• Accuracy:
• Bore:
• Nominal Flow Rate:
• Calibration:
12.5 - 16 volts Negative earth system.
0.9 amps approxImately.
2 Amps each
Hall effect type sensors
3 pin weather-pak plug (Pin A, B and C)
2-3 millimeters (mm)
Supply 12 volts from MDECU
4 -5- volts sensor inactive
< 1 volt sensor activated by magnet
Open Circuit
1800 Ohms
50 milli amps
2% in range 10% to 200% of nominal flow
15mm
80l/min
45.7 pulse/l
V 1.2
V 1.0 11/05
98
- Quick Links:
- Set the Flow Calibration Factor
Hide quick links:
Advertisement
Table of Contents
