Table of Contents
Advertisement
E15h SPRAYER- Pressure Alarm
V 1.0 11/05
4.5.1 ENABLE THE PRESSURE 1 LOW ALARM
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2 the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 1,until the focus is on PRESSURE ALARMS
• Press ENTER to select PRESSURE ALARMS
• Press ENTER to edit PRESSURE 1 LOW. An asterisk (*) will be displayed
• Press INC/DEC buttons to switch the alarm ON or OFF
• Press ENTER to accept the changes
4.5.2 SET THE PRESSURE 1 LOW ALARM POINT
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 1, until the focus is on PRESSURE ALARMS
• Press ENTER to select PRESSURE ALARMS
• Press LINE 1, until focus is on ALARM POINT
Note: If alarm is OFF, to switch the alarm ON. See Section 4.5.1
• Press ENTER to edit the value. An asterisk (*) will be displayed
• Press INC/DEC buttons to set the alarm point in 10kPa increments
• Press ENTER to accept the changes
4.5.3 ENABLE THE PRESSURE 1 HIGH ALARM
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2 the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 1,until the focus is on PRESSURE ALARMS
• Press ENTER to select PRESSURE ALARMS
• Press LINE 2, the focus is on PRESSURE 1 HIGH
• Press ENTER to edit PRESSURE 1 HIGH. An asterisk (*) will be displayed
• Press INC/DEC buttons, to switch the alarm ON or OFF
• Press ENTER to accept the changes
54
- Quick Links:
- Set the Flow Calibration Factor
Hide quick links:
Advertisement
Table of Contents
