Adjustment Of The Cultivator; Working Depth Adjustment; Adjustment Of The Central And Rear Deflectors - UNIA Ares HP Operating And Maintenance Manual

Disc cultivator

Table of Contents

3.5. Adjustment of the Cultivator

Adjustment by means of bolts consists of blocking the upper jib position. We achieve this by

•

placing the bolt A in a corresponding hole in the plate B while lowering or lifting the machine

on its chassis.

•

Perform hydraulic adjustment by pressurizing the cylinder (C) from the tractor cab, which

extends the cylinder. Then, put on the required number of stops (D) and pressurize the

cylinder (C) again to slide it back to the stops (D). Through this, you can raise or lower the

rear roller of the machine. Secure the cylinder (C) against dropping down with the lever (E).

Tines A can be adjusted in one direction.

For vertical direction: remove the cotter pin (B) and lift up or lower the row of tines (A), locking it in

the selected holes with the cotter pin (B.)

OPERATING AND MAINTENANCE MANUAL ARES HP

Fig. 8: Working depth adjustment

a – mechanical adjustment

b – hydraulic adjustment

Fig. 9: Adjustment of the deflector

- 14 -

Table of Contents