Setting Up The Remote Modem; Modem Setup Dialog Box For Remote Modem - Siemens SIMATIC S7-200 System Manual
Hide thumbs
Also See for SIMATIC S7-200:
- System manual (554 pages) ,
- Getting started (65 pages) ,
- Manual (55 pages)
Table of Contents
Advertisement
Setting Up Communications Hardware and Network Communications
Setting Up The Remote Modem:
1.
In the Communications Setup dialog box, double-click on the second modem
icon (Figure 7-11). The Modem Setup dialog box for the remote modem
appears (Figure 7-14).
2.
In the Remote Modem area, select your modem type. If your modem is not
listed, select the "Add" button to configure your modem. To do this, you must
know the AT commands for your modem. Refer to the documentation for your
modem.
3.
In the Communications Mode area, select the communications mode (either
10-bit or 11-bit). The communications mode that you select depends upon
your modem capabilities. (The 10-bit and 11-bit communications modes are
described later in this section.) Both the local and the remote modem must
have the same communications mode. Click the "Configure" button.
4.
The Configure dialog box appears (Figure 7-15). If you are using a predefined
modem, there are no fields that you can edit. If you are not using a predefined
modem, you must enter the AT command string for your modem. Refer to the
documentation for your modem.
5.
To test the configuration of your remote modem, click the "Program/Test"
button while the modem is connected to your local machine (programming
device or PC). This action transfers the parameters into a memory chip in the
remote modem.
6.
Click the "OK" button. The Communications Setup dialog box appears.
Modem Setup
Local Modem
Remote Modem
Communications Mode
Figure 7-14
7-20
Bausch Induline IL 14K4 (11-bit)
Add
Note: Both Local and Remote Modems must communicate using
the same communications mode.
10-Bit Communications
11-Bit Communications
Modem Setup Dialog Box for Remote Modem
Remove...
OK
S7-200 Programmable Controller System Manual
Configure...
Cancel
A5E00066097-02
- Quick Links:
- Installing an S7-200 Micro Plc
- Configuration
Hide quick links:
Advertisement
Table of Contents
