Table of Contents
Advertisement
Installing an SFP+ module
The SFP+ module provides two fiber-optic cable connectors for connecting to
external ports. To install an SFP+ module, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. If you have not already done so, touch the static-protective package that
3. Read the information in "Handling an SFP+ module" on page 11.
4. Remove the SFP+ module from its static-protective package.
5. Remove the protective cap from the SFP+ module and store it in a safe place.
6. Insert the SFP+ module into the SFP+ module port until it clicks into place.
7. Connect the fiber-optic cable (see "Connecting the SFP+ module cable" on
12
IBM BladeCenter 1/10 Gb Uplink Ethernet Switch Module: Installation Guide
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
`
Appareil A Laser de Classe 1
on page 5.
contains the SFP+ module to an unpainted metal surface of the BladeCenter
chassis or an unpainted metal surface on any other grounded rack component
in the rack in which you are installing the switch module for at least 2 seconds.
Attention:
To avoid damage to the cable or the SFP+ module, make sure that
you do not connect the fiber-optic cable before you install the SFP+ module.
page 15) and any cables that you disconnected earlier.
Advertisement
Table of Contents
