Table of Contents
Advertisement
Chapter 3. Installing and removing a 10 Gb SFP+ module
The switch module supports the 10 Gb small-form-factor pluggable (SFP+) module.
The SFP+ module is a laser product that converts electrical signals to optical
signals.
For additional information about the location of the switch module, the network
interface requirements, and expansion options, see the documentation for your
BladeCenter unit.
Note: The illustrations in this document might differ slightly from your hardware.
Handling an SFP+ module
Before you install an SFP+ module, read the following information:
v The module housing of the SFP+ has an integral guide key that is designed to
v Use minimal pressure when you insert the module into the port. Forcing the
v You can insert or remove the module while the BladeCenter unit is turned on.
v You must first insert the module into the port before you can connect the cables.
v You must remove the cable from the SFP+ module before you remove the SFP+
© Copyright IBM Corp. 2012
prevent you from inserting the module incorrectly.
module into the port can cause damage to the module or the module port.
module from the switch module.
Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
– Do not remove the covers. Removing the covers of the laser product
could result in exposure to hazardous laser radiation. There are no
serviceable parts inside the device.
– Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
11
Advertisement
Table of Contents
