Initiator Manage Initiator Commands - IBM TotalStorage DS300 Best Practices Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

The align, piggyback and ping parameters set up initial values for the initiator's

attributes. By default, the align parameter is enabled, the piggyback and ping

parameters are disabled. For more information, (see initiator manage initiator

destroy initiator_list

Destroy the remote iscsi initiators in the initiator_list list. This removes all

references to these initiators from any targets or other entities which refer to

info [name_list]

Output information about all specified remote iSCSI initiators

Including only one initiator in the name_list list produces the same results as

using the iscsi initiators manage initiator info command.

List all of the known remote iSCSI initiators.

Display IQN of local system's initiator.

A.16.1 initiator manage initiator commands

These commands manage remote iSCSI initiators. These commands are

available after the global initiator manage initiator command, from the global

context by preceding them by initiator initiator, or from the iSCSI initiators

context by preceding them with manage initiator.

align enable | disable

Change whether Protocol Data Units (PDUs) should be aligned on Ethernet

IBM TotalStorage DS300 and DS400 Best Practices Guide

enable | disable

Administrator

enable | disable

Administrator

enable | disable

Administrator

Totalstorage ds400