IBM TotalStorage DS300 Best Practices Manual page 470

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

Note: The described tasks can only be performed from the command line

interface (CLI).

1. Use a Telnet to connect to one of the management IPs of the DS400. This

book uses as example controller A. Logon with administrative rights.

----[ IBM DS400: Command Line Interface ]----------------------------------

Peer controller status: Ready

DS400[A]> administrator

Administrator level password: ********

Figure 9-2 Logon

2. Get the list of initiators and aliases defined during setup of the DS400.

DS400[A]# initiator list

Fibre Channel Initiators

210000e08b0f1549

210000e08b0ff748

210000e08b170d75

210000e08b17d774

Figure 9-3 Initiator list

IBM TotalStorage DS300 and DS400 Best Practices Guide

Firmware: IBM TotalStorage DS Series (Build 0743)

[20/07/2005][6.21]

Typing 'help': provides an overview of the commands available to

configure the controller.

TAB key: use the TAB key as a means of getting assistance

in completing any commands that you issue.

[WOLGA-SLOT4-(1)]

[WOLGA-SLOT3-(0)]

[RIOGRANDE-S4-(1)]

[RIOGRANDE-S3-(0)]

Totalstorage ds400