IBM TotalStorage DS300 Best Practices Manual page 561

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

1. Open a Telnet connection to one of the controllers in the DS400 and logon as

administrator. To logon with administrative rights enter administrator.

----[ IBM DS400: Command Line Interface ]----------------------------------

Firmware: IBM TotalStorage DS Series (Build 0743)

Peer controller status: Ready

Typing 'help': provides an overview of the commands available to

TAB key: use the TAB key as a means of getting assistance

DS400[A]> administrator

Administrator level password: ********

Figure 9-139 Logon as administrator

2. Get a list of the available initiators by entering initiator list.

DS400[A]# initiator list

Fibre Channel Initiators

210000e08b0f1549

210000e08b0ff748

210000e08b170d75

210000e08b17d774

Figure 9-140 List initiators

3. Look for the initiators of WOLGA and check port access for every singly initiator

by entering initiator manage WOLGA-SLOT4-(1) info. All ports are disabled for

this initiator.

[20/07/2005][6.21]

configure the controller.

in completing any commands that you issue.

[WOLGA-SLOT4-(1)]

[WOLGA-SLOT3-(0)]

[RIOGRANDE-S4-(1)]

[RIOGRANDE-S3-(0)]

Chapter 9. TotalStorage DS400 installation

Totalstorage ds400